What Should Be Paid Attention to when Installing Angle Valve

1. When we install the angle valve, everyone should flush the water pipe. Because during the installation of the water pipe, some dust, sand, etc. may enter the inside of the water pipe. The sundries inside the water pipe will affect the water flow, resulting in less water output and so on. Open the water pipe to rinse, and the impurities inside the water pipe can be washed out.
2. When installing the angle valve, you need to wrap the raw material tape around the angle valve. The raw material tape should be wound along the thread direction of the angle valve, and the raw material tape should be tightly wound, usually more than ten turns. If the raw material tape is left against the thread direction of the angle valve, or the raw material tape is not tightly wound, or the number of winding turns of the raw material tape is too small, it will affect the sealing performance of the angle valve, and it is easy to cause water leakage.
3. After the angle valve is installed, it needs to be checked and accepted. We can open the main water valve in the house and observe whether there will be water dripping at the connection of the angle valve. If the angle valve leaks, you have to remove the angle valve and reinstall it. Before installing the angle valve, we also need to check the quality of the angle valve. If an inferior angle valve is used, the angle valve is more prone to water leakage and other problems.