No, a full crimping tool is required Brass Press Fittings require a full crimping tool for installation. The tool applies the necessary force. Partial tools cannot create a proper
Sep 30, 2026
Jaw profile determines the crimp shape Brass Press Fittings require the correct jaw profile. V-profile and M-profile are two common types. Each creates a different crimp shape. Exa
Excellent performance under vibration Brass Press Fittings perform well in seismic and vibration-heavy environments. The crimped connection is permanent and does not loosen. It is
Definition and basic purpose Brass Press Fittings are mechanical connectors made from brass. They join pipes without heat or solder. A pressing tool crimps the fitting onto the pip
Faster installation Brass Press Fittings install much faster than soldered connections. A press connection takes only seconds. Soldering requires heating and cooling time. Example:
Pressing tool is the primary tool Brass Press Fittings require a pressing tool for installation. The tool applies force to compress the fitting. Manual and battery-powered tools ar
Metric sizes for international use Brass Press Fittings are available in metric sizes. Common sizes include 15mm, 18mm, 22mm, and 28mm. Larger sizes go up to 108mm. Example: a 22mm
Yes, they are suitable when certified Brass Press Fittings are suitable for potable water systems when certified. They must meet NSF/ANSI 61 standards. The materials must be safe f
Yes, with proper certifications Brass Press Fittings can be used for gas lines with proper certifications. They must meet specific gas safety standards. Not all press fittings are
Different joining mechanisms Brass Press Fittings use a pressing tool to crimp the fitting. Compression fittings use a nut and ferrule. The mechanisms are completely different. Exa
No, they are not reusable Brass Press Fittings are designed for one-time use only. The pressing process permanently deforms the fitting. It cannot be reused after installation. Exa
Maximum temperature depends on the seal Brass Press Fittings have a maximum temperature that depends on the O-ring. EPDM O-rings handle up to 250°F (121°C). HNBR O-rings ha
