1. Note that the materials should be prepared in advance
Before starting hot-melting, prepare hot-melting equipment and utensils to avoid confusion during the hot-melting process. At the same time, it is necessary to understand the power and frequency of the equipment, and then select the appropriate power and a good ground connection to prevent leakage and ensure Safe to use.
2. Pay attention to the cutting method
When cutting, the sections of the two PE pipes should be smooth and clean, and at the same time, ensure that there are no impurities, so that the welding effect is good. After the cutting work is completed, first remove the milling cutter, then close the furniture, and then check the gap at both ends, which cannot exceed 0.3mm.
3. Note that the pipe must be clamped
When the Pe pipe is hot-melted, the pipe should be put into the hot-melting equipment first, and the appropriate clamp should be selected according to the design for clamping, and the clamp must be firm and easy to cut. In addition, it should be noted that the positions of the two pipes must be on the same level, and the cutting allowance must be more than 10mm, but not more than 20mm. Therefore, when connecting pipes, be sure to ask professionals to operate them to ensure that there will be no problems during installation and that they can be used safely.