1. After the water pipe material enters the site, the first thing to do is to check the water pipe material to see if it is the same model as the material you ordered, and to see if the material is damaged. Must be completed on time. In addition, pay attention to the surface of the material and whether there are anti-counterfeiting standards to ensure its quality.
2. If you need to install hot and cold water pipes, you need to design the distance between the two pipes, not less than three centimeters. In addition, in the early stage of grooving, the position of the hot and cold water pipes should be clearly defined. Hot water is usually on the left and cold water is on the right. If the situation changes, be sure to explain in advance, so as not to affect the normal use.
3. If it is a metal pipe clamp, the distance between the two points should be controlled at more than 80cm. Metal pipe clamps are generally used to repair water pipes, and the effect is quite good. During construction, it is necessary to determine the position of the metal pipe clamp, then drill holes and insert wooden wedges, and fix the metal pipe clamp with screws.
4. During the hot-melting process of the water pipe, the temperature should be controlled at about 260 degrees Celsius. After 5 seconds of hot-melting, the water pipe should be connected in time. The longer the time, the worse the connection effect, the water pipes must be welded in parallel and cannot be rotated.