The common faults and solutions of water heating parts are as follows:
Joint Leakage
The joint leakage may be caused by unreasonable pipe sleeves, incorrect winding packing, missing gasket at the live joint, missing welding of the pipe and other factors. Solutions include rewiring, replacing filler, adding gaskets or rewelding.
Drain Clogging
Cement mortar and debris falling into the drain can cause clogging. The solution includes blocking the sealing operation at the spout during construction to avoid debris falling into the pipeline.
Water Nozzle Is Not Tightly Closed Or Closed
The water nozzle may be loosely closed due to factors such as wear of the leather pad or broken cores. Solutions include replacing parts such as leather pads or cores. When the water nozzle cannot be closed, the water nozzle cover should be opened, the valve stem or the valve spike should be replaced, or the water nozzle should be replaced.
Too Little Circulating Water
Too little circulating water may be caused by factors such as pump reversal, pipeline blockage, and incomplete opening of valves. The solution includes checking and adjusting the rotation direction of the pump, cleaning the pipeline, cleaning the valve and other measures.
Heating Pipe Installation Defects
Heating pipe installation defects may cause problems such as air blockage, incorrect position of pipe fixing supports, and improper position of the main pipe ejector. The solution includes adjusting the slope of the pipeline, adjusting the position of the support, and resetting the position of the spout.
The Temperature Of The Water Supply Fluctuates
The high and low temperature of the water supply may be caused by factors such as the instability of the boiler water supply temperature. The solution includes taking corresponding measures to keep the boiler water supply temperature stable.
System Partial Overpressure
The overpressure of some buildings in the system may cause damage and leakage of heat dissipation equipment and accessories. The solution includes asking the technical department according to the required water pressure of each building. The pressure regulating plate is installed on the water supply pipe at the heating inlet device of some buildings. The aperture of the regulator plate should be re-selected if the regulator plate has been installed.
The above are some common faults and solutions of water heating parts for reference.