How to install pex pipe with compression fittings

May 31, 2023

Installing PEX (cross-linked polyethylene) pipe with compression fittings involves the following steps:

pex pipe

1. Measure and Cut

Measure the required length of PEX pipe and use a PEX pipe cutter to make a clean, straight cut.

2. Prepare the Fittings

Slide a compression nut onto the pipe, followed by the compression ring (also known as the ferrule). Ensure the fittings are compatible with PEX pipe and are the correct size.

3. Insert the Pipe

Insert the end of the PEX pipe into the compression fitting until it reaches the fitting's shoulder or depth mark.

4. Tighten the Nut

Hand-tighten the compression nut onto the fitting. Then, use a wrench to make a final quarter to half-turn to secure the connection. Avoid over-tightening, as it may damage the fittings or cause leaks.

5. Check for Leaks

Once all connections are made, turn on the water supply and carefully inspect each compression fitting for any signs of leaks. If leaks are detected, tighten the compression nut slightly until the leak stops.

 

It is essential to follow manufacturer guidelines and instructions specific to the compression fittings and PEX pipe being used. Consulting with a professional plumber or following local plumbing codes is recommended to ensure proper installation.

Send Inquiry